Is There Asbestos in Your Spokane Valley Home?
Homes and buildings built before 1980 are most at risk. Common locations include:
- Popcorn/textured ceilings (common in Spokane Valley-area homes built 1960–1978)
- Floor tiles and tile adhesive (9" vinyl floor tiles are a major red flag)
- Pipe insulation and duct wrap in older HVAC systems
- Attic insulation, particularly vermiculite (gray, pebble-like material)
- Roof shingles and siding on pre-1980 constructions
- Drywall joint compound and textured paint
Asbestos Removal Costs in Spokane Valley (2026)
Prices from licensed Spokane Valley-area contractors. Ranges reflect project size and material type.
Washington & Spokane Valley Asbestos Regulations
What the law requires before, during, and after removal work in Spokane Valley.
Federal EPA Requirements
All asbestos removal projects must comply with the National Emission Standards for Hazardous Air Pollutants (NESHAP). Contractors must provide written notification to the EPA before demolition or renovation of regulated facilities.
40 CFR Part 61 Subpart MWashington Licensing (L&I)
Washington requires asbestos contractors and workers to be licensed through the Washington Department of Labor & Industries (L&I); local clean air agencies enforce air rules. License categories: Asbestos abatement contractor certification; certified worker, supervisor, inspector, management planner, project designer.
WAC 296-62-077 (Washington Industrial Safety & Health Act Asbestos Rules)OSHA Worker Safety
Workers must receive proper training and respiratory protection. Permissible Exposure Limit (PEL) is 0.1 fibers per cubic centimeter of air over an 8-hour period.
29 CFR 1926.1101Waste Disposal
Asbestos waste must be wetted, double-bagged in 6-mil poly bags, labeled, and disposed of at a Washington Department of Ecology-permitted landfill. Local clean air agency notification required.
WAC 173-303 / Ecology rulesLocal Spokane Valley Rules
Spokane Valley is within Spokane County, where the Spokane Regional Clean Air Agency (SRCAA) enforces EPA NESHAP asbestos notification requirements for demolition and renovation projects, in addition to Washington L&I asbestos abatement contractor certification requirements.
Local agency notification requiredWhat the Removal Process Looks Like
A typical Spokane Valley asbestos project from start to finish.
Initial Inspection & Testing
A certified inspector collects bulk samples and sends them to an accredited lab. Results come back in 24–72 hours. You receive a written report confirming which materials contain asbestos.
Contractor Selection & Permitting
For commercial projects, your contractor must notify Washington Department of Labor & Industries (L&I); local clean air agencies enforce air rules and file required paperwork before work begins (typically 10 working days lead time under federal NESHAP). Residential rules vary; reputable contractors follow the same protocol.
Containment Setup
Workers seal off the work area with 6-mil polyethylene sheeting, create a negative air pressure environment, and set up a decontamination unit. HVAC systems are disabled to prevent fiber spread.
Removal & Disposal
Materials are wetted before removal to suppress fibers, carefully removed, double-bagged, and transported to a permitted asbestos-receiving landfill. Workers wear full PPE including P100 respirators.
Clearance Air Testing
After removal, an independent industrial hygienist conducts final air testing. The area is not cleared for re-occupancy until fiber counts fall below 0.01 f/cc.
Frequently Asked Questions
Common questions from Spokane Valley homeowners and property managers.