Is There Asbestos in Your Moore Home?
Homes and buildings built before 1980 are most at risk. Common locations include:
- Popcorn/textured ceilings (common in Moore-area homes built 1960–1978)
- Floor tiles and tile adhesive (9" vinyl floor tiles are a major red flag)
- Pipe insulation and duct wrap in older HVAC systems
- Attic insulation, particularly vermiculite (gray, pebble-like material)
- Roof shingles and siding on pre-1980 constructions
- Drywall joint compound and textured paint
Asbestos Removal Costs in Moore (2026)
Prices from licensed Moore-area contractors. Ranges reflect project size and material type.
Oklahoma & Moore Asbestos Regulations
What the law requires before, during, and after removal work in Moore.
Federal EPA Requirements
All asbestos removal projects must comply with the National Emission Standards for Hazardous Air Pollutants (NESHAP). Contractors must provide written notification to the EPA before demolition or renovation of regulated facilities.
40 CFR Part 61 Subpart MOklahoma Contractor Licensing
Oklahoma requires asbestos contractors and workers to be licensed through the Oklahoma Department of Environmental Quality (DEQ), Air Quality Division, Asbestos Section; Oklahoma Department of Labor licenses contractors.
OAC 252:100-41 (Oklahoma DEQ Asbestos Emission Standards); OAC 380:50 (Oklahoma Asbestos Control Act, Dept. of Labor)OSHA Worker Safety
Workers must receive proper training and respiratory protection. Permissible Exposure Limit (PEL) is 0.1 fibers per cubic centimeter of air over an 8-hour period.
29 CFR 1926.1101Waste Disposal
Asbestos waste must be wetted, double-bagged in 6-mil poly bags, labeled per DOT requirements, and disposed of at a permitted landfill authorized to accept asbestos under state and federal guidelines.
40 CFR Part 61 Subpart MLocal Moore Rules
No additional municipal asbestos rules confirmed beyond Oklahoma state requirements; federal NESHAP and state contractor licensing apply.
Verify requirements with local authorityWhat the Removal Process Looks Like
A typical Moore asbestos project from start to finish.
Initial Inspection & Testing
A certified inspector collects bulk samples and sends them to an accredited lab. Results come back in 24–72 hours. You receive a written report confirming which materials contain asbestos.
Contractor Selection & Permitting
For commercial projects, your contractor must notify the Oklahoma Department of Environmental Quality (DEQ), Air Quality Division, Asbestos Section; Oklahoma Department of Labor licenses contractors and file required paperwork before work begins (typically 10 working days lead time under federal NESHAP). Residential rules vary; reputable contractors follow the same protocol.
Containment Setup
Workers seal off the work area with 6-mil polyethylene sheeting, create a negative air pressure environment, and set up a decontamination unit. HVAC systems are disabled to prevent fiber spread.
Removal & Disposal
Materials are wetted before removal to suppress fibers, carefully removed, double-bagged, and transported to a permitted asbestos-receiving landfill. Workers wear full PPE including P100 respirators.
Clearance Air Testing
After removal, an independent industrial hygienist conducts final air testing. The area is not cleared for re-occupancy until fiber counts fall below 0.01 f/cc.
Frequently Asked Questions
Common questions from Moore homeowners and property managers.