Find licensed, state-certified asbestos abatement contractors serving Brighton. Understand local regulations, typical costs, and what to expect.
Get Free Contractor QuotesRegulations change. Always verify current requirements with the licensing body and notifying agency before beginning any asbestos project.
Cost ranges are sourced from HomeAdvisor national cost data and adjusted for Colorado market conditions.
| Project Type | Typical Range |
|---|---|
| Popcorn / Acoustic Ceiling Texture (per sq ft) | $3–$7 |
| Floor Tile & Adhesive (per sq ft) | $5–$12 |
| Pipe Insulation (per linear foot) | $10–$20 |
| HVAC / Duct Insulation | $500–$4,000 |
| Roofing (per sq ft) | $5–$15 |
| Full Home Abatement | $1,500–$10,000 |
Note: Colorado near national avg, slightly above in the Denver metro; Brighton/Adams County (northeast Denver suburb) draws from the Denver metro market. Source: HomeAdvisor. Get free quotes for exact Brighton pricing.
Brighton has approximately 38% of its housing stock built before 1980 (median year built: 1983), when asbestos was widely used. Common Colorado housing types include: ranch homes, 1960s–1970s suburban development, mid-century commercial, post-war residential.
9×9 and 12×12 vinyl tiles installed before 1980 frequently contain asbestos; the black mastic adhesive beneath them often does too.
Corrugated wrap on steam and hot-water pipes, boiler jackets, and elbow fittings in pre-1980 homes and commercial buildings.
Spray-applied texture and "popcorn" acoustic ceiling products applied before 1978 commonly contain asbestos.
Duct wrap, duct tape, vibration collars, and HVAC insulation in pre-1980 systems often contain asbestos-containing materials (ACM).
Pre-1977 joint compound (drywall mud) and plaster products frequently contain asbestos; sanding disturbs fibers most.
Asbestos-cement shingles, transite siding, and roofing felt were common in residential and commercial construction through the 1970s.
A state-accredited asbestos inspector surveys the property and collects bulk samples for laboratory analysis. Do not disturb suspected ACM before inspection.
Before work begins, the licensed contractor submits notification to Colorado Department of Public Health and Environment (CDPHE), Air Pollution Control Division (Denver) at least 10 working days in advance for qualifying renovation or demolition projects (40 CFR Part 61 Subpart M; 5 CCR 1001-10 Regulation No. 8, Part B (Colorado Asbestos Rules)).
Workers erect negative-pressure containment, wear HEPA-filtered respirators (NIOSH-approved half-face or full-face APF ≥ 10), and use wet methods to suppress fiber release during removal.
Aggressive air sampling and phase-contrast microscopy (PCM) or transmission electron microscopy (TEM) clearance testing confirms the area meets safe fiber levels before containment is removed.
ACM waste is double-bagged in 6-mil poly bags, labeled per EPA/DOT requirements, and transported to a licensed hazardous waste disposal facility.
Yes. Colorado requires Colorado General Abatement Contractor (GAC) Certification; certified supervisor, worker, inspector, management planner, project designer, and air monitoring specialist required. Unlicensed removal violates state law and can result in significant fines. Always verify contractor license status with Colorado Department of Public Health and Environment (CDPHE), Air Pollution Control Division, Asbestos Program.
Small projects (floor tile, ceiling texture) typically take 1–3 days. Full home abatement may take 1–2 weeks. Factor in the 10-working-day advance notification requirement before work can begin.
Typical full-home abatement in Brighton ranges from $1,500 to $10,000. Costs vary by scope, ACM type, and site access. Get multiple quotes from licensed contractors for accurate Brighton pricing.
Homeowners may collect samples, but samples must be analyzed by an accredited laboratory (NVLAP-accredited). For pre-renovation surveys, Colorado may require a state-accredited inspector. Do not sand, drill, or disturb suspected ACM before testing.
Encapsulation (applying a sealant or covering ACM in place) is permitted in some situations where the material is in good condition and won't be disturbed. A licensed inspector must assess whether encapsulation is appropriate; notification requirements still apply for qualifying projects.